INSTALLING WINDOWS SOUND DRIVERS
================================


REQUIREMENTS

     * HP OmniBook 5700 installed with Windows 3.1 or Windows for Workgroups 

     * HP OmniBook 5700 Sound drivers.  The drivers are located on the OmniBook
       hard disk in C:\OMNIBOOK\DRIVERS\WFW\SOUND\DISK1 and DISK2 directories.
       These files are available after finishing the selection of Windows 95 or
       Windows for Workgroups during the pre-install process.  The files are
       also located on the HP OmniBook Recovery CD in the 
       \DRIVERS\WFW\SOUND\DISK1 and DISK2 directories.

Note: The Windows Sound drivers must be installed from floppy disk. The Sound 
      drivers are located in two subdirectories 
      C:\OMNIBOOK\DRIVERS\WFW\DRIVERS\SOUND\DISK1 and ..\SOUND\DISK2.  Copy
      these directories to two floppy disks.


PROCEDURE

1. Start Windows

2. Insert the HP OmniBook 5700 Sound Drivers Disk in the A: drive

3. Choose the File menu then Run

4. Enter A:\SETUP and press <ENTER>.

5. Follow the instructions displayed. (choose the defaults). 

6. It will require several entries of the path to the DISK2 directory.

7. Exit Windows and Reboot.  When Windows starts, you should hear the default
   Windows sound and a Crystal Semiconductor wave file.

Note: Ensure the following lines where entered in your AUTOEXEC.BAT and 
      CONFIG.SYS 


      CONFIG.SYS
      ----------
      DEVICE=C:\CRYSTAL\CS4232C.EXE

      AUTOEXEC.BAT
      ------------
      C:\CRYSTAL\CS32MIX /C=13 /L=13
      SET BLASTER = 220 I5 D1 T4


