

     +=======================================+
     |	NetWare 3.x disk drivers for DC-200  |		   Version 1.02
     +=======================================+

     Enclosed in the subdirectory "NETWARE" are two releases of NetWare 3.x
     disk drivers for the DC-200 Disk Accelerator.

     PTIA310.DSK   is for NetWare 3.10.
     PTIA311.DSK   is for NetWare 3.11.


     You will need the driver under the following situations:

     - You want to install TURBO MODE under NetWare 3.1x.
     - Your DC-200 is installed as the PRIMARY disk controller with
       more than two IDE drives attached.
     - Your DC-200 works as the SECONDARY disk controller.

     Please  follow the steps below to install the driver for NetWare 3.10.
     Use PTIA311.DSK instead of PTIA310.DSK in the following procedure when
     you are installing NetWare 3.11. Note that the ISADISK.DSK driver is
     substituted by the TURBO MODE PTI driver in the NetWare installation.

     1. When your DC-200 works as the PRIMARY disk controller.

	- After you have installed the DC-200, bring up the NetWare server
	  until the prompt ":" appears on the screen.

	- Type the following command after the ":" prompt:

	       load PTIA310 port=1f0 int=e


     2. When your DC-200 works as the SECONDARY disk controller.

	- Install DC-200 as the SECONDARY disk controller.  Please follow
	  steps 2 through 8 in the root directory README file under
	  "Secondary Controller Operation."

	 -Bring up the NetWare server until the prompt ":" appears on the
	  screen.

	- Type the following command after the ":" prompt if your
	  DC-200 has been configured to use IRQ12.

	       load PTIA310 port=170 int=c

	  If your DC-200 has been configured to use IRQ15, you should
	  type the following command instead of the one shown above.

	       load PTIA310 port=170 int=f

