OS/2 for Windows Install Instructions
for the Viper Version 1.0


These instructions assume that the Viper has already been installed under the 
DOS/Windows environment using a default installation.  If you located the 
Viper files and utilities in a different location, change the paths below as 
appropriate. 

1.  Install OS/2 for Windows using the standard VGA driver.

2.  Install the Viper OS/2 2.1 drivers per the instructions included with 
    those drivers.

3.  Open up an OS/2 windowed or full screen command prompt.  Type the 
    following two commands:

	COPY Y:\OS2\MDOS\WINOS2\*.* Z:\WINDOWS
	COPY Y:\OS2\MDOS\WINOS2\SYSTEM\*.* Z:\WINDOWS\SYSTEM

	Y is the drive where OS/2 for Windows has been installed.
	Z is the drive where Microsoft Windows has been installed.

4.  Edit your SYSTEM.INI file (it is located in the Windows directory).  There 
    should be a line that reads:

	fdisplay.drv=vga.drv

    Change this to read as follows:

	If you selected 256 colors, the line should read:

		fdisplay.drv=p9000_08.drv

	If you selected 65,000 colors, the line should read:

		fdisplay.drv=p9000_16.drv

	If you selected 16.7 million colors, the line should read:

		fdisplay.drv=p9000_32.drv

    Save the SYSTEM.INI file.

5.  You should now be able to run Windows applications seamlessly and full-
    screen under OS/2 for Windows with the Viper.
	

